Latin writing system

From The Toaq Wiki
Revision as of 23:43, 27 May 2024 by Laqme (talk | contribs) (Move technical info to Unicode)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Toaq is most commonly written using a modified Latin writing system, with diacritics on the vowels to mark tone.

Alphabet

The alphabet, in native order, is:

m b p f n d t z c s r l nh j ch sh q g k ' h a u ı o e
/m/ /b/ /pʰ/ /f/ /n/ /d/ /tʰ/ /d͡z/ /t͡sʰ/ /s/ /ɾ/ /l/ /ɲ/ /d͡ʑ/ /t͡ɕʰ/ /ɕ/ /w~j/ /ŋ/ /ɡ/ /kʰ/ /ʔ/ /h/ /a/ /u/ /i/ /o/ /ɛ/

Not all fonts and keyboards have the letter . The refgram suggests using v as a replacement. People also commonly use w or vy or y.

In semi-native order, the consonants are ordered in the Latin/Unicode way (b, c, ch, d…) while the vowels are still at the end, in a, u, ı, o, e order.

In non-native or Latin order, the whole alphabet is ordered like the Latin alphabet: a, b, c, ch, d…

The vowel ı is written without its dot to avoid confusion with the tone diacritics listed below.

Diacritics

Tone marking

The following diacritics are placed on the first vowel (a, u, ı, o, e) of a word to mark non-default tone on the whole word:

Nr. Mark On "a" Diacritic Unicode Tone name
1 falling tone a falling tone
2 rising tone á acute accent U+0301 rising tone
3 glottal tone ä diaeresis U+0308 falling-glottal tone
4 hiatus tone â circumflex U+0302 rising-falling tone

Prefix marking

In addition, the underdot (, U+0323) is used to mark the presence of a prefix, more specifically the last in a run of prefixes if any are present. It may be replaced by the ASCII hyphen (-) in case the underdot isn’t available on your keyboard. While the underdot falls on the first vowel of the prefix raku (so where a tone mark would’ve gone), the hyphen should be placed between the last prefix and the word’s stem. For example, kı- + ne- + shı may be written as kınẹshı or kıne-shı; hao- + chuq = hạochuq or hao-chuq.

See also